×
(866)205-5299
All Departments
Exterior
Interior
Performance
Drivetrain
Suspension & Steering
RV, Trailers, & Towing
Exhaust
Audio & Video
Lighting
Shop Supplies & Equipment
Powersports, ATVs/UTVs & Cycles
Marine & Watersports
My Account
My Garage

Your Garage


Goodmark/ProEFX 97-03 f150 standard 2in rise cowl steel hood (see additional info for drilling instructions)

By Goodmark/ProEFX
Part #: FRD97V3

This product is no longer offered.
Have questions? Call us at 866-205-5299

Description

ProEFX is aware the FRD97V3 Hood does not have pre-drilled windshield washer holes. Until further notice, the holes will have to be drilled using the following directions. 1. Remove the OE nozzle from the OE hood. 2. Measure the size of the hole to figure out what size drill bit you will need. 3. Measure the location of each hole on the OE hood 4. Mark on the cowl hood the location of where to drill the hole for the nozzle. 5. Drill the hole BUT just make sure it is the exact same size as the OE so the nozzle will fit snug like the OE one did. 6. Put the washer fluid hose back on the bottom of the nozzle and fish it down through the new hole and then reinstall the nozzle. Note - Once installed since the cowl hood sits higher the washer nozzle will need to be adjusted to it does not shoot over the hood. Most of the time you can use a paperclip or a small flat head screwdriver to adjust the nozzle.

Specifications

Custom Hood Material
Steel

Reviews

There are no reviews for this product yet.